Overview
PERCE's important product - Extended Tool Holder 100, can be equipped with vibrating knives, circular knives, pneumatic knives, drag knives, bevel cutters, milling cutters, pressure wheels, half cutters, table collectors, etc.
The Extended Tool Holder 100 uses extended double guide rails and precision screw drive to achieve Z-axis lifting and lowering, and uses synchronous belt drive to achieve tool rotation.
Extended tool holder100
Component Description
Coupling: used to connect the Z-axis motor and the lead screw
Locking wire: fix the tool
Stop pin: when installing the tool and tightening the locking wire, press the stop pin to prevent the tool barrel from rotating
Base plate: used to fix the tool holder
Tensioning wheel: used to adjust the tension of the synchronous belt
Synchronous wheel: installed on the R-axis motor
R-axis motor bracket: control the tool rotation motor installation position
Z-axis motor bracket: control the tool lifting motor installation position
Synchronous belt: connect the large and small synchronous wheels
Installation Dimensions
Installation Diagram
Instructions for use and debugging
Lead and gear ratio: lead of screw rod 4mm, gear ratio of synchronous wheel 1:4.
Limit switch output: default output NPN NO.
Stop pin operation: press the stop pin and rotate the knife barrel (synchronous wheel) until the stop pin is inserted into the hole; at this time, the stop pin is stuck in the knife barrel, and the locking wire can be loosened by hand or wrench.
Wiring Instructions
The default power supply for the knife holder red light is DC5V, and the default power supply for the limit switch is DC24V
| Red light crosshair | Red：DC5V+ Black：DC5V- |
| Z-axis limit switch | brown：DC24V+ blue：DC24V- black：Signal line |
| R-axis limit switch | brown：DC24V+ blue：DC24V- Signal line see label (black or white) |
Precautions
- Before powering on, make sure the wiring is correct.
- Use shielded cables to avoid interference.
- Make sure the coupling is tight.
Order Model
Product Parameters
| Order Model | Perce91187 |
| Number of tools that can be installed | 1 |
| journey | 147/207/277 |
| Dimensions | -A stroke 207 W105/H339.5/D144.5 -B1 stroke 147 W105/H301.5/D144.5 -C stroke 277 W105/H409.5/D144.5 |
| Weight | Different sizes have different weights |
Shipping Configuration
Extended knife holder 100
-A route 207mm
-B1 route 147mm
-C route 277mm
Optional accessories
Knife seat pressure plate
Heightened knife seat pressure plate
Servo Motor
Optional spare parts
Couplings
Small synchronous wheel of knife seat
Knife holder belt
Rotary limit switch
Z-axis limit switch
Red light indicator
Reviews
There are no reviews yet.